Chevrolet Chevelle 1977 Repair Manual page 281

2. Using tool J-25019-9 with Driver Handle J-8092,
drive or press new bushing into place until tool bottoms
(Fig. 7A-179A).
REAR SUN GEAR
1. Using tool J-25019-14 with Slide Hamm er J-7004-1,
remove bushing (Fig. 7A-180A).
2. Place rear sun gear with gear side down on block of
wood to prevent damaging the gear.
3. Using tool J-25019-2 with Driver Handle J-8092,
drive or press new bushing into place until tool bottoms
(Fig. 7A-181 A).
LO AND REVERSE CLUTCH HOUSING
BUSHING
1. Using tool J-25019-16 with Slide H am m er J-7004-1,
remove bushing (Fig. 7A-182A).
2. Place lo and reverse clutch housing with splined hub
between two blocks of wood to prevent damaging the
splines.
3. Using tool J-25019-8 with Driver H andle J-8092,
drive or press new bushing into place until tool bottoms
(Fig. 7A-183A).
REAR CARRIER BUSHING
1. Using tool J-25019-16 with Slide H am m er J-7004-1,
remove bushing (Fig. 7A-184A).
2. Using tool J-25019-7 with Driver Handle J-8092,
drive or press new bushing into place until tool bottoms
(Fig. 7A-185A).
CASE BUSHING
1. Using tool J-2 1424-9 with Driver Handle J-8092,
remove bushing (Fig. 7A-186A).
2. Using tool J-2 1424-9 with Driver Handle J-8092,
drive or press new bushing to a distance of approximately
17.3mm (11/16") between rear end of the bushing and rear
end of the case (Fig. 7A-186A).
AUTOMATIC TRANSMISSION
Fig. 7A-1 8 2 A - R e m o v in g Lo and Reverse Clutch Ho using
Fig. 7 A - 1 8 3 A — I nsta 1 1 i ng Lo and Reverse C lu tch Housin g
B ushin g
B u s h in g
Fig. 7A-1 84A-R em ovin g Rear Carrier Bushing
(200)7A-45
J-7004-1
J-25019-16
LO & REVERSE
CLUTCH
HOUSING
25019 8
& REVERSE
LUTCH
HOUSING