Chevrolet Chevelle 1977 Repair Manual page 246

(200)7A-10
5. Inspect reverse clutch seal and interm ediate band
anchor pin bores for damage.
6. Inspect vent assembly in case for damage. Do not
remove unless replacement is required.
7. Inspect for damaged or stripped bolt holes. If any
threaded holes require heli-coils or equivalent, install these
to renew the threads.
8. Turn transmission to vertical position, rear end up.
9. Inspect cooler line connectors for damage. Do not
remove unless replacing.
10. Inspect case bushing for damage or scoring.
11. If removed, install a new oil seal, using J-2 1426
(Fig. 7A-51A).
INSIDE DETENT LEVER
MANUAL SHAFT
Fig. 7A-42A--Removing Manual Shaft Nut
OVERHAUL MANUAL
Fig. 7 A-4 1 A - M a n u a l S h a ft and Parking S h a ft Parts
equivalent, to the outside diam eter of the vent that locates
in the case and Loctite 35, or equivalent, to the vent hole
in the case. Install vent, using a rubber or plastic hammer.
connector(s); torque connector(s) to 20.0-27.0 N -m (15-20
ft. lbs.).
MANUAL SHAFT AND PARKING PAWL
PARTS (Fig. 7A-52A)
Inspection
lever and separate.
12. If vent was removed, apply Loctite Prim er "T", or
13. If removed, install new cooler line washer(s) and
1. Align actuator rod tangs with hole in inside detent
Fig. 7A -43A-R emoving Manual Shaft from Case