Troubleshooting - Yamaha YZF-R1K Service Manual

EB803020

TROUBLESHOOTING

The starter motor fails to turn.
Check:
1. main and ignition fuses
2. battery
3. starter motor
4. starting circuit cutoff relay
5. relay unit
6. starter relay
7. main switch
8. engine stop switch
9. neutral switch
10. sidestand switch
11. clutch switch
12. start switch
13. wiring
(of the entire starting system)
NOTE:
• Before troubleshooting, remove the
following part(-s):
1) rider seat
2) fuel tank
3) air filter case
4) front cowling inner panel (left)
5) windshield
• Troubleshoot with the following spe-
cial tool(-s).
EB802400
1.Main and ignition fuses
• Check the main and ignition fuses for
continuity.
Refer to "CHECKING THE FUSES" in
chapter 3.
• Are the main and ignition fuses OK?
8
ELECTRIC STARTING SYSTEM
Pocket tester
YU-03112
YES
Replace the fuse(-s).
EB802401
2.Battery
• Check the condition of the battery.
Refer to "CHECKING AND CHARGING
THE BATTERY" in chapter 3.
Open-circuit voltage
• Is the battery OK?
EB803400
3.Starter motor
• Connect the battery positive terminal 1
and starter motor lead 2 with a jumper
lead 3.
WARNING
WARNING
• A wire that is used as a jumper lead
must have at least the same capacity of
NO
the battery lead, otherwise the jumper
lead may burn.
• This check is likely to produce sparks,
therefore make sure that no flammable
gas or fluid is in the vicinity.
• Does the starter motor turn?
8 - 18
ELEC
12.8 V or more at 20 ˚C (68 ˚F)
YES
• Clean the battery
terminals.
• Recharge or
replace the battery.
YES
Repair or
the starter motor.
– +
NO
NO
replace