Yamaha YZF-R1K Service Manual page 248

CARBURETORS
2. Install:
• pipes
• fuel feed pipes
• vacuum chamber pipe
• vacuum chamber air vent hose
• springs
• float chamber air vent hoses
• hose joints
• spacers
• copper washer
• connecting bolts
NOTE:
• Do not tighten the connecting bolts,
yet.
• Install the throttle valve lever 1 onto
carburetors #1, #2, and #4 between the
spring 2 and synchronizing screw 3.
3. Install:
• starter plunger link 1
NOTE:
Install the starter plunger link 1 onto
each starter plunger.
4. Tighten:
• connecting bolts
NOTE:
• Place the carburetor assembly on a
surface plate with the intake manifold
side down. Then, tighten the connect-
ing bolts while pushing down the car-
buretor assembly with an even force.
• After tightening the connecting bolts,
check that the throttle valve lever and
starter plunger link operate smoothly.
5. Install:
• starter cable 1
NOTE:
Install the starter cable holder 2 onto
the starter cable.
6 - 9
CARB
7 Nm (0.7 m · kg, 5.1 ft · lb)
6