Yamaha YZF-R1K Service Manual page 308

7
FRONT FORK
c. Install the rod puller and adapter onto
the damper rod.
Rod puller
YM-01437
Adapter
90890-01436
d. Install the fork spring, spring seat,
and spacer.
NOTE:
Install the spring with the smaller
pitch a facing up Å .
e. Press down on the spacer with the
fork spring compressor 7.
f. Pull up the rod puller and install the
rod holder 8 between the nut 1 and
the spacer 4.
NOTE:
Use the side of the rod holder that is
marked "B".
Fork spring compressor
YM-01441
Rod holder
YM-01434
g. Remove the rod puller and adapter.
h. Install the nut 1 and position it as
specified b.
Distance b
11 mm (0.43 in)
i. Install the damper adjusting rod and
cap bolt, and then finger tighten the
cap bolt.
j. Hold the cap bolt and tighten the nut
to specification.
Nut
15 Nm (1.5 m • kg, 11 ft • lb)
k. Remove the rod holder and fork
spring compressor.
WARNING
WARNING
• The fork spring is compressed.
• Always use a new cap bolt O-ring.
7 - 54
CHAS