System Setup; General; Figure 8: System - General Setup Screen - Speco D4CX Operation Instruction Manual

System Setup

General

Highlight the Site box and press the
you have entered your title, highlight OK and press the
Highlight the box beside System ID and press the
and Down arrow buttons to increase and decrease the number from 0 to 99.
NOTE: The System ID number is used to identify the unit when it is connected with other DVRs through the RS485
port. You cannot use the same ID number for two or more DVRs that are in the same RS485 network.
It is possible to have multiple DVRs with System ID 0 that are in the same area as long as they are not
part of an RS485 network. If this is the case, all will be controlled at the same time when using the infrared
remote control.
Highlight the box beside Language and press
the desired language and press the
The box beside Version displays the software version of the DVR. To upgrade the software, connect a USB device
containing the upgrade package file to the DVR. Highlight Upgrade... and press the
appears. The screen displays the upgrade package file names that are available. The ".rui" indicates that the file is for
software upgrades.
Select the desired file and press the
the selected software package. Highlighting the Cancel button and pressing the
upgrading the software. If the upgrade package file is not installed on the DVR properly, you will get an error message.
The system restarts automatically after completing the upgrade.
CAUTION: The USB device must be FAT16 or FAT32 format.
Figure 8: System – General setup screen.
button. A virtual keyboard appears that you can use to enter a Site Name. Once
button.
button. Change the number by highlighting it and using the Up
button. A drop-down menu displays the available languages. Highlight
button.
button. Highlighting the Install button and pressing the
Digital Video Recorder
button. The Upgrade screen
button will install
button will close the window without
13