Belling FSE 60 DOP Service Manual page 29

To set the time of day
A
Press the Up and Down buttons
N
together for a few seconds, and
release.
The 'G' in between the numbers on
N
the LED Display will begin to flash.
While the 'G' is flashing it is possi-
N
ble to adjust the time using the Up and
Down buttons.
been set, allow approximately 30 sec-
onds before using any of the other
timer functions. This ensures that the
time will remain correct.
To select an alarm tone
There are three tones to chose from.
Press and hold the down button to lis-
N
ten to the first tone.
Release the down button and press it
N
again to listen to the second tone etc.
Releasing the down button after the
N
tone has sounded will automatically
select that tone
PROGRAMMER / CLOCK
Once the time has
Setting the minute minder
To set the Minute Minder, press the
N
Function button once. The bell symbol
will appear and start flashing.
flashing only lasts for 5 seconds so the
time must be set within this time frame.
Use the Up and Down button to set
N
the length of time required. Once this
has been done, the Minute Minder is
set.
When the desired length of time has
N
counted down the alarm will sound.
To cancel the tone, press any of the
N
buttons.
To cancel the Minute Minder at any
N
time, press the Up and Down buttons
together.
24
The