Ordering Charts - Graco 600 Instructions Manual

The charts below provide a cross reference between
identification numbers stamped on the parts and the
Graco part number. Chart 1 shows the complete gun
assemblies available, grouped by basic gun type.
Chart 2 shows fluid nozzle/needle combinations. Chart
3 shows the air caps available.
The following is an example of how to use these
charts:
Your application calls for a pressure feed gun .
Chart 1 shows this to be a P600 basic gun .
Chart 1: Gun Combinations Available
P600: Pressure Feed Guns
Combinations:
Ordering Gun
Part No.
217–600 P600
217–601 P600
S600: Siphon Feed Guns
Combinations:
Ordering Gun
Part No.
217–602 S600
217–605 S600
Terms:
Light Fluid: 19 to 24 seconds (No. 2 Zahn cup). Auto, furniture, appliances, fine-finish metallics, top coats, lacquer,
enamel primers.
Medium Fluid: 22 to 41 seconds (No. 2 Zahn cup). Contact adhesive, latex, maintenance paints, textures, primers,
epoxies, vinyls, high flow – high viscosity.
Heavy Fluid: Mastics, block fillers, roof coating, sound deadeners, adhesive, textures.

Ordering Charts

Nozzle Air Cap
See Chart 2 See Chart 3
0 0
02 02
Nozzle Air Cap
See Chart 2 See Chart 3
2 2
3 31
Using Chart 2, the flow rate required and fluid vis-
cosity call for an 02 fluid nozzle and needle combi-
nation .
By using Chart 3, you determine that the 02 air cap
is best for the application.
This makes your combination a P600–02–02 . Chart
1 shows that the Graco part number for this combi-
nation is 217–601 .
G600: Gravity Feed Guns
Combinations:
Ordering Gun
Part No.
217–607 G600
217–609 G600
Nozzle Air Cap
See Chart 2 See Chart 3
2 21
3 31