Inspecting The Crankshaft Alignment; Standard Diameter - PIAGGIO 633929(IT) Service Station Manual

MP3 125
Check the diameters of both bearings of the crank-
shaft according to the axes and surfaces shown in
the figure. The half-shafts are classified in two cat-
egories Cat. 1 and Cat. 2 as shown the chart
below.
Characteristic
Standard diameter - Category 2
29.004 ÷ 29.010
Standard diameter - Category 1
28.994 ÷ 29.000
Specification
Standard diameter - Category 2
Standard diameter - Category 1

Inspecting the crankshaft alignment

Measure the capacity of both axes X-Y
Specific tooling
020074Y Support base for checking crankshaft alignment
Titolo
Crankshaft alignment

STANDARD DIAMETER

C
RANKSHAFT ALIGNMENT
Durata/Valore Testo Breve (< 4000
Desc./Quantity
29.004 ÷ 29.010
28.994 ÷ 29.000
Indirizzo Immagine
car.)
Engine
ENG - 51