End Gear; Removing The Hub Cover; Removing The Wheel Axle; Removing The Hub Bearings - PIAGGIO 633929(IT) Service Station Manual

MP3 125

End gear

Removing the hub cover

- Empty the rear hub through the oil drainage plug.
- Remove the 7 flanged screws indicated in the
figure.
- Remove the hub cover and its gasket.

Removing the wheel axle

- Remove the wheel axis complete with gear.
- Remove the intermediate gear.

Removing the hub bearings

- Check the state of the bearings being examined
(wear, clearance and noisiness). If faults are de-
tected, do the following.
- Use the specific bearing extractor to remove the
three 15 mm bearings (2 in the crankcase and 1 in
the hub cover).
Specific tooling
001467Y013 Pliers to extract ø 15-mm bearings
Engine
ENG - 17