Operate Common Problem Solving - Ipcam IP Camera User Manual

port number and try again.
3 Port mapping is not success. You can do port mapping by two ways:
Enter setting page of the router which IPCAM connect with to enable UPnP function.
Enter IPCAM "UPnP Settings" to enable UPnP and make sure the state is "UPnP
success".

If your router has the Virtual Map function. Enter router setting page, add IPCAM‟s IP
and port to the Virtual map list.
When use ADSL, the IP is dynamic. You should set DDNS(see more details 3.5.4 & 5.1.6)
and also make sure port mapping success.

5.2 Operate common problem solving

IP camera tool can't find the camera?
Except of the camera broken
1. Make sure the cable connector no problem, recommend connector
(AMP),it is with international standard. Another note, IPCAM's data
transmission channel require higher than computer's, so maybe the
computer can run normally but IPCAM can't, Please press heavily when
making the cable connector.
2. Confirm the power supply normally. First, check whether power indication
light turn on or not, If it is on,then check the yellow light on RJ45 Port
(power indication light) and green light (network indication light) are on or
not.If they are on,so power supply and cable runs normally.
3. Confirm all the firwall and antivirus software are close.The firewall often
block unrecognized data so if the firewall is running ,so maybe the IPCAM
TOOL can't find the device.Suggest to close firewall and antivirus
software temporarily before searching.
How to solve the camera blank screen?
1. Check if you are using the wrong power adaptor.please use original
one.
2. Close antivirus software.
How to solve the camera can't login by Internet?
1. Check if you set DDNS success or not?
2. Check the current IPCAM's port number is the same as router's?They
need to keep same.
Can't view the monitoring picture
1. Reason: can't connect with network
Solution:Check if the network connect well, exclude cable fault and PC virus
cause network fault until can be used between PC and PING.
IPCAM User Manual
60 / 67