Table of Contents
Advertisement
With this application program the followng functions can be parametrized and configured:
Application Program: EEL_RTH1_10 Room Thermostat
Max number of group addresses: 35
Max number of group address associations: 32
General Configuration
Temperature
Regulation
Configuration
Setpoint Configuration
Input Configuration
Configurazione
Relay di uscita
Note: The default settings for the options are underlined (e.g. Options: no/yes)
Cyclical sending of actual temperature (environment)
•
Cyclical sending of actual setpont temperature
•
Power failure and recovery alarm enable
•
Type of temperature regulation (ON/OFF, P, I, PI)
•
Type of HVAC plant (2/4 tubes ON/OFF, 2/4 tubes
•
Proportional)
Fan Coil type (1,2,3 speeds or proportional regulation)
•
Temperature sensor adjastment (calibration)
•
Temperature coefficient regulation (hysteresis)
•
Setpoint settings for Comfort, Stand-by, Economy modes
•
in Summer/Winter conditions (Cooling/Heating)
Setpoint antifreeze winter (frost protection)
•
User's setpont temperature range regulation setting
•
"Window Switch" or "General Purpose" functions setting
•
Window switch mode (normally opened or closed)
•
If "General Purpose" switching states ON or OFF can be
•
set depending on input pulse adge evalutation (rising or
falling edge).
Cyclical sending option at adjustable intervals
•
"General Purpose" or "Velocity V1 Fan Coil"
•
Normally open or closed contact setting
•
Timed OFF switching (e.g.: "Door lock timing release")).
•
9 di 30
Pagina
Advertisement
Table of Contents
