Mounting And Wiring Hints - Eelectron TM11A01KNX Product Handbook

2.4 Mounting and wiring hints

The device may be used for permanent indoor installations in dry locations within wall
boxes.
Requirements for installation
The device must not be connected to 230V cables.
•
The prevailing safety rules must be heeded.
•
The device must be mounted and commissioned by an authorised installer.
•
The applicable safety and accident prevention regulations must be observed.
•
The device must not be opened. Any faulty devices should be returned to manufacturer.
•
For planning and construction of electric installations, the relevant guidelines, regulations
•
and standards of the respective country are to be considered.
Requirements for commissioning
Connect each single KNX/EIB bus core inside the bus connection terminal block
•
observing bus polarity .
Slip the bus connection block into the guide slot placed on the front side of this device
•
and press the block down to the stop.
In order to commission the device, a PC with ETS2 version V1.3 or higher is required as
•
well as an interface to the bus, e.g. via an
The device configuration (KNX physical address assignment) is done by pressing the
•
programming push button located on the front of the housing.
Supplied state
The device is supplied with the physical address 15.15.255.
•
It is therefore necessary to load parameters and group addresses during
•
commissioning. However the complete application program can be reloaded if required.
The bus connection terminal block is included in the package.
•
The instruction sheet is included in the package.
•
Manutenance
The device is maintenance free.
•
In case of damage during transportation or storage, no repairs my be carried out by
•
external staff.
When the device is opened the right to claim under guarantee expires.
•
RS232 interface or via a USB interface.
6 di 30
Pagina