Eelectron TM11A01KNX Product Handbook page 26

Nr. Funzione
3 On/Off
After receiving the object from the bus, the thermostat goes in Winter mode (when
receiving 1) or in Summer mode (when receiving 0).
The fixed temperature Set point is used when passing from Winter mode to Summer
mode and vice versa.
Note: the thermostat TM11A01KNX (TM11A11KNX) doesn't toggle automatically
between Summer (Cooling) and Winter (Heating) mode but only by receiving this object
from the bus.
4 Real actual setpoint
With this object the real last setpoint value, concerning the actual operating mode
(summer/winter and comfort, economy or standby) is sent to the bus.
The real actual value is calculated from the base setpoint ± the user variation
introduced with the front push buttons.
This object is sent cyclically (if enabled with specific parameter) or at any changes or
after ETS download.
5 Comfort setpoint value
setting
This object is used to set the Comfort base setpoint via bus, normally by a centralized
unit. This value is stored in a non volatile memory.
6 Standby setpoint value
setting
This object is used to set the Standby base setpoint via bus, normally by a centralized
unit. This value is stored in a non volatile memory.
7 Economy setpoint
value setting
This object is used to set the Economy base setpoint via bus, normally by a centralized
unit. This value is stored in a non volatile memory.
8 Actual temperature
value
Acutal temperature is transmitted to the bus with this object. The temperature value is
sent in case of temperature variation or, if enabled by the parameter, cyclically.
Nome
0 = Summer / 1=Winter
Actual SetPoint
Setpoint Base Comfort
Setpoint Base StandBy
Setpoint Base Economy
Actual Temperature
Tipo Flag
EIS1, 1 bit C,R,W,T
DPT 1.001
EIS5, 2 byte C,R,W,T
DPT 9.001
EIS5, 2 byte C,R,W,T
DPT 9.001
EIS5, 2 byte C,R,W,T
DPT 9.001
EIS5, 2 byte C,R,W,T
DPT 9.001
EIS5, 2 byte C,R,W,T
DPT 9.001
26 di 30
Pagina