Art.sl5488; Slim Hands Free Videomonitor - Videx VX2300 User Manual

Art.SL5488

Fig.1
DESCRIPTION
An intelligent Hands-free surface video monitor employing a colour 3.5" active matrix LCD display, with push buttons for "door open/intercommunicating
call", "answer/camera recall", "privacy on/off", "BUS relay activation" and 2 service buttons plus 4 LED's associated with 4 main buttons. In addition to
the above the unit has controls for loudspeaker volume, call tone volume, brightness and hue with programmable number of rings, privacy duration and
intercommunication mode.
PUSH BUTTONS, LEDS AND CONTROLS (FIG.1)
Service push button - When pressed, shorts terminal "S1" to terminal "GND" (ground).
Bus Relay Button to Activate bus relay board Art.2305. To activate a bus relay press as many times as the address value of the relay.
Answer button - On an incoming call, operation of this button allows the user to answer and converse with the visitor. LED 2 will illumi-
nate.
Camera recall button - Press as many times as the DEVICE N. of the door station to switch on.
Switch off button - With the system switched on (monitor on), momentary operation of the button will switch the video monitor off. The
videomonitor will also automatically switch off after a time delay if the button is not pressed. LED 2 will switch off.
Simplex button - Pressing and holding the button for more than 3 seconds will switch the videomonitor into SIMPLEX speech mode.
Press and hold the button to speak to the caller (LED 2 will flash rapidly), release the button to listen (LED 2 will flash slowly). If the but-
ton is not pressed for 10 seconds the videomonitor will switch off. The videomonitor will revert to duplex speech when another call is
made.
When pressed, shorts terminal "S2" to Terminal "GND" (ground).
Privacy on-off button:
 If the monitor is switched on, press and keep pressed this button for more than 3 seconds to enable/disable the service. The relative
LED will illuminate when the privacy service is enabled.
 If the monitor is switched off, keep this button pressed together with the "speak" button
Camera select button - With a conversation in progress, press to switch from door station camera to external camera (requires Art.4330N
and external camera) and viceversa.
Intercommunicating call button - For an intercommunicating call, when the videomonitor is in stand-by, press as many times as the ex-
tension or address value to call.
Door open button - During a call, operation of this button will activate the "door open" relay (NO1, NC1, COM1). LED 4 will illuminate if
terminal 6 has been connected to a door contact.
1 LED for programming purposes
2
LED relating to the operation of the answer/switch off/camera recall/simplex button
3 LED relating to the operation of privacy button
4
LED relating to the operation of door open button(powered from the connection terminal "6" of Art.5980)
Loudspeaker volume control
Call tone volume control
Brightness control
Colour intensity control
PrtCode:VX2300_2_9.doc – Pag.21

Slim Hands Free Videomonitor

3
1
4
2
130,00
VX2300 2 Wire Video Digital System
1
2
3
4
5
6
7
8
9
10
08/03/2011
11
12
13
14
15
16
17
18
19
20
ON ON
1 2 3 4 5 6 7 8 1 2 3 4
SW1 SW3
ON ON
1 2 3 4 5 6 7 8 1 2 3 4
until the privacy LED switches ON.
Fig.2
Rev.2.9