Installation - EF BO-AE101-A Instructions For Installation And Use Manual

performing maintenance;
- When left unused, unplug the appliance form the electricity mains;
- Use oven gloves to place cookware in the oven or when removing it;
- Always grip the oven door handle in the center as the extremities of the same may be hot due to any hot air
leaks;
- Cut the power supply cable after disconnecting it from the mains when you decide not to use the appliance
any longer.
·The manufacturer may not be held responsible for any damage due to :Incorrect installation, improper, incorrect
and irrational use.
Only a qualified person in compliance with the instructions provided must install the appliance. The
manufacturer declines all responsibility for improper installation, which may harm persons and animals and
damage property.
Important: - The power supply to the appliance must be cut off before any adjustments or maintenance work is
done on it;
- Air duct is supposed to use in Ventilation.
Installation of Built-in Ovens
In order to ensure that the built-in appliance functions properly, the cabinet containing it must be appropriate .The
figure below gives the dimensions of the cut-out for installation under the counter or in a wall cabinet unit.
N. B: Installation in compliance with the consumption declaration
In order to ensure adequate ventilation ,the back panel of the cabinet unit must be removed .Installing the oven
so that it rests on two strips of wood is preferable .If the oven rests on a continuous ,flat surface ,there must be an
aperture of at least 45×560mm .
The panels of the adjacent cabinets must be made of heat-resistant material .In particular ,cabinets with a veneer
exterior must be assembled with glues which can withstand temperatures of up to 100℃.

Installation