Panasonic WJ-GXE100 Installation Manual page 13

Screw tightening
• The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
• Do not use an impact driver. Use of an
impact driver may damage the screws or
cause tightening excessively.
• Tighten screws at a right angle to the sur-
face. After tightening screws, perform visual
check to ensure that the tightening is suffi-
cient enough so that there is no movement
or looseness.
Radio disturbance
When this product is used near TV/radio anten-
na, strong electric field or magnetic field (near a
motor, a transformer or a power line), images
may be distorted and noise sound may be pro-
duced.
PoE (Power over Ethernet)
Use a PoE hub/device that is compliant with
IEEE802.3af standard.
Router
When connecting this product to the Internet,
use a broadband router with the port forward-
ing function (NAT, IP masquerade).
Refer to the Operating Instructions on the pro-
vided CD-ROM for further information about
the port forwarding function.
Time & date setting
It is necessary to set the time & date before
putting this product into operation. Refer to the
Operating Instructions
CD-ROM for descriptions of how to perform
the settings.
on the provided
For BNC coaxial cable connection
Use only the recommended plug below when
connecting a BNC coaxial cable (locally pro-
cured) to the video input connector on the unit.
BNC coaxial cable (locally procured)
Applicable plug: MIL-C39012C or MIL-C39012/16F
* Suffixes attached to the standards may be
updated.
BNC coaxial cable (locally procured)
Plug
Plug
<Tip dimensions inside the recommended plug>
ø1.32 mm - ø1.37 mm
ø1.32 mm - ø1.37 mm
ø0.13 mm - ø0.69 mm
IMPORTANT:
• Use a compatible plug. Failure to observe
ø0.13 mm - ø0.69 mm
this may cause trouble such as poor con-
tact. At worst, the connector of this prod-
uct may be damaged.
13