Hardware Installation Manual
The Ethernet LEDs are located in the RJ-45 socket. The table below describes these LEDs.
Table 3-3: MP-124 Rear-Panel Ethernet LEDs Description
Label
ETHERNET
3.2
Unpacking and Checking Package Contents
Follow the procedure below for unpacking the carton in which MP-124 is shipped.
To unpack MP-124:
1.
Open the carton and remove packing materials.
2.
Remove the MP-124 unit from the carton.
3.
Check that there is no equipment damage.
4.
Ensure that in addition to the MP-124 unit, the package contains the following items:
•
Only for AC-powered model: AC power cable
•
Only for DC-powered model: unwired DC terminal block with two crimping screws
•
Two short equal-length brackets and bracket-to-device screws for 19-inch rack
installation.
•
Regulatory Information document.
5.
Check, retain and process any documents.
6.
Notify AudioCodes or your local supplier of any damage or discrepancies.
Version 6.6
Color
State
Green
On
Red
On
23
3. MP-124 Hardware Installation
Function
Valid 10/100Base-TX Ethernet connection.
Malfunction.
April 2012