Using The Juicer - Black & Decker JBGM600-B5 User Manual

Warning ! Allow moving parts to come to a stop
before approaching.
Assembling the juicer
• Wash all detachable parts (see chapter
'Maintenance and cleaning').
• Place the juice collector (G) on to the motor
base (H).
• Put the rotary sieve (F) in the juice collector
(G).
• Make sure the rotary sieve (F) is fitted
securely onto the driving shaft ('click').
• Always check the rotary sieve (F) before use.
If you detect any cracks or damage, do not
use the appliance and contact the nearest
service centre or take the appliance to your
dealer.
• Place the juicer lid (E) onto the juice collector
(G).
• Lock the clamp (J) onto the juicer lid (E) to
lock it into place ('click') and slide the pusher
(D) into the feeding tube by aligning the
groove in the pusher with the small
protrusion on the inside of the feeding tube.
Never insert your fingers or an object into the
feeding tube.
• Place the pulp collector (K) in to position at
the side of the juicer.
• Place a jug under the spout.
Assembling the Blender
• Wash all detachable parts (see chapter
'Maintenance and cleaning').
• Fit the blender jug (C), to the motor base (H)
and secure by turning it anti-clockwise.
Note: Ensure that the blender is switched off
before removing it from the stand.
Assembling the grinder
• Wash all detachable parts (see chapter
'Maintenance and cleaning').
• Fit the grinder seal (P) into the groove
around the edge of the grinder blade (Q).
• Secure the blade (Q) into the grinder jug (O)
by pushing it into the jug and turning it
clockwise.
• Fit the grinder jug (O) to the motor base (H)
and secure it by turning it anti-clockwise.
Assembling the mincer
• Wash all detachable parts (see chapter
'Maintenance and cleaning').
• Fit the mincer seal (M) into the groove
around the edge of the mincer blade (N).
• Secure the blade (N) into the mincer jug (L)
by pushing it into the jug and turning it
clockwise.
• Fit the mincer jug (L) to the motor base (H)
and secure it by turning it anti-clockwise.
Use
The following settings are available:-
P = Pulse Operation
O = Power Off
1 = Low Speed
2 = High Speed
The appliance should be disconnected
from the mains supply before removing
the jug.

Using the juicer

• Place the appliance on a flat, stable surface
and connect it to the electrical supply.
• Select the required speed (P, 1 or 2) using
the CONTROL KNOB (I).
• Remove the pusher & add the ingredients,
using the pusher to guide the ingredients
onto the blades.
While you are preparing juice, you can empty
the pulp container by switching the appliance off
and carefully removing the pulp container.
ENGLISH
5