Connecting The Cables To The Touchmonitor And Computer - Elo TouchSystems ET2200L User Manual

Connecting the Cables to the Touchmonitor and Computer

Audio Audio
Input Output
To connect the touchmonitor to the computer:
1 Tilt the monitor to reveal the connector panel in the recessed area underneath the
bottom edge of the monitor.
2 Connect the AC power cable to the connector panel and connect the other end to the
power outlet.
3 Connect either the USB cable OR the serial cable to the connector panel. Note: Do
not use both. This cable connects the touchmonitor to your computer. Attach the
other end to your computer.
4 Connect the video cable (VGA) or the DVI-D cable to the connector panel. Tighten
by turning the two thumb screws clockwise to ensure proper grounding. Connect the
other end to your computer.
5 Connect the audio cable to the Audio Input on the connector panel and connect the
other end to your computer.
6 Press the power button on the side panel of the monitor to turn on the monitor.
Connector Panel Underneath the Monitor
VGA DVI-D Serial USB LED DC
In
Elo TouchSystems 2200L User Guide 9
Power