Chapter 4: Calibration; Introduction; User Calibration - Raymarine ST60+ Owner's Handbook Manual

Chapter 4: Calibration

4.1 Introduction

Use this chapter to set up and check the ST60+ Graphic Display, before it is used
operationally. Instructions are given to enable you to:
• Define the function of the NMEA OUT connector (see
Connections
• Carry out Dealer calibration.
• Check basic operation.

4.2 User calibration

A User calibration facility enables you to:
• Set the Favorite page rollover period, or switch the rollover off.
• Switch chapter titles on or off.
• Set whether headings are displayed in true or magnetic form.
• Check and set the depth offset value. Only available if suitable information is
available from NMEA.
• Set the voltage at which a battery alarm will occur.
• Enable/disable individual local alarms.
• Set the date format.
• Set the time format.
• Set the instrument time to local time.
• Select the units in which NMEA data are displayed.
• Select the function of the display NMEA OUT connector. This is either
• A remote alarm output for the Auxiliary Alarm (NMEA OFF).
• NMEA output signals.
• Enable/disable individual remote alarms.
• Enable/disable the pilot pop up display.
• Configure the instrument to display specific pages.
).
or
Chapter 1, System
35