24
2. Using both thumbs, gently press an upper corner of the instrument from the
bezel, then remove the bezel from the instrument. Retain the rubber keypad
which is released when the bezel is removed.
3. Referring to the
seal (8) in the corresponding recess on the back of the flush mount bezel (7).
Fitting the flush mount bezel
4. Place the instrument (11) face upwards on a flat surface, then place the rub-
ber keypad (10) in position around the display window (i.e. so that each but-
ton outline is located over its associated button on the instrument).
5. Place the keypad seal (9) in position on the keypad (i.e. so that the holes in the
seal accept the appropriate keypad buttons).
6. Place the assembled flush mount bezel and panel seal, in position on the
instrument, so that the rubber keys are correctly located in the holes on the
bezel, then clip the bezel and instrument together.
CAUTION: Use the correct screws
It is essential that only screws of the correct size are used to
secure the instrument to the bezel. Failure to observe this caution
could result in damage to both the instrument and the bezel.
Fitting the flush mount bezel
7
ST60+ Graphic Display Owner's Handbook
illustration, insert the panel
8
9
10
11
12