Teaching The Pav Remote Control New Commands - PROCEED Digital Surround Decoder User Manual

teaching the PAV remote
control new commands
After the command has been successfully learned, both the
and
learned/sending
mote control is ready to repeat the process.
4 REPEAT THE PROCESS OF "TEACHING" NEW COMMANDS TO THE
VARIOUS BUTTONS ON THE PAV REMOTE CONTROL UNTIL FINISHED.
Y ou may, of course, add additional commands at any time. Just be careful
not to assign two commands to the same button (in the same bank), as
this will cause the second command to overwrite the first one, making it
unavailable for use.
5 PRESS "USE/LEARN" AGAIN WHEN YOU ARE DONE, IN ORDER TO
RETURN TO NORMAL "USE" MODE
Y ou may now use your PAV remote control in place of the one you just
used to teach the PAV remote its "new tricks." In the normal
PAV remote control will transmit the various commands it has been "taught"
to associate with particular buttons, allowing you to put away the other re-
mote.
6 TEST ALL YOUR NEW "LEARNED" COMMANDS TO ENSURE THAT THEY
WERE "LEARNED" CORRECTLY
As with all learning remote controls, it is sometimes possible for the PAV
remote control to learn either partial or multiple command bursts from the
original remote control. If you experience unexpected behavior when using
the PAV remote in lieu of the original, simply reteach the offending com-
mand. Y ou may want to try either a quick tap or a more extended press of
the original remote control's button in order to get it to send a complete
(but not redundant) control signal for the PAV remote control to learn. Try
to avoid brightly lit areas, or areas lit by strong fluorescent lights, when
teaching any learning remote control new commands. If it is impractical to
dim the lights a bit, provide some shade between the remotes by holding
this owner's manual (or something similar) over the remote controls while
teaching new commands.
LEDs will light once again, indicating that the PAV re-
ready to learn
use mode, the
65