Control Trigger 2 Menu; Rear Ir Input Menu - PROCEED Digital Surround Decoder User Manual

Warning!

control trigger 2 menu

rear ir input menu

Important:
52
Digital Surround Decoder can provide). If this is the case, you can use
trigger 1 as a switch by placing it in series with an external power source such as
a "wall wart" power supply .
There are no user serviceable parts inside the PDSD. If you
need one of the internal settings changed to support your
installation, please contact your dealer.
The
control trigger 2 menu
that only control trigger 1
nal power source such as a "wall wart" power supply . See control trigger 1 menu,
above.
The infrared remote input jack on the rear panel of the PAV may be programmed
to respond to either
local
receiver in the PAV's
main display
peater, to affect only the remote
Turn-on section of your PAV manual for more information.)
The factory default setting is
vents IR commands from reaching the PAV (as when behind closed doors, for ex-
ample), and if you are using an IR repeater to pass IR commands to the system,
you may wish to set the IR input on the rear panel to
would also want to "hard-wire" the PAV to your IR repeater. To make this software
change, follow these steps:
1 ENTER THE CUSTOM MENU
This menu is accessed from the
custom , and pressing
2 SELECT REAR IR INPUT
volume ±
Using the
enter.
3 TOGGLE THE MENU ITEM FROM REMOTE TO LOCAL
Press either of the
volume +/–
to . Press
remote local
Note that this change will not take effect until you back out of
the on screen menus and return to normal operation. This
delayed response allows you to continue to use the IR
receiver on the main display long enough to finish what you
are doing. It will be turned off in favor of the IR input jack
once you leave the menu system.
is exactly the same as that for
can be set for use as a dry contact relay with an exter-
commands (e.g., duplicating the functionality of the IR
) or commands (e.g., from an IR re-
remote
signal path). (Refer to the Remote IR and Remote
. If your installation of the PAV/PDSD pre-
remote
main menu by moving the cursor to
enter to select the menu item.
buttons, move the cursor to
keys to change the default setting of
to save the change.
enter
control
, except
conrtol trigger 1
, in which case you
local
rear IR input and press