Front Panel - PROCEED Digital Surround Decoder User Manual

P R O C E E D
16
1
d i g i t a l s u r r o u n d d e c o d e r
digital processing

Front Panel

1 DIGITAL PROCESSING LED
This digital processing LED
source has been chosen, indicating that no digital signal processing is even
being attempted.
If the PDSD cannot communicate with the PAV (due to a forgotten commu-
nications cable, for example), the
cate that it is trying (but not succeeding) to communicate with the PAV .
The digital processing LED
lected, but cannot be "locked" onto and used. (Example: the RF output of a
laserdisc player typically goes "dead" during scanning, chapter searches, and
side changes, interrupting the signal and preventing the Digital Surround
Decoder from doing what you have "asked" it to do.)
Finally, the
digital processing LED
both been chosen and is being successfully received, indicating that digital
processing is possible.
The Digital Surround Decoder will automatically and transparently decode
(including a digital version of
PCM
merly called
form of digital decoding and processing the signal requires. In any of these
cases, the digital processing LED will glow amber to indicate that the Digital
Surround Decoder is handling the signal for you.
If you wish to learn which of these digital processes is active, press the
button on the remote control.
status
is normally completely
digital processing LED
glows red when a digital signal has been se-
glows amber when a digital signal has
Dolby Pro Logic
AC-3 ), DTS Coherent Sound
2
L U C A S F I L M
TM
®
power
off when an analog
will
blink
),
Dolby Digital
, and MPEG , switching to whatever
to indi-
(for-