Control Trigger 1 Menu - PROCEED Digital Surround Decoder User Manual

6

control trigger 1 menu

This menu is used to configure and define how you want the PDSD trigger #1 to
operate. When you enter this menu, you see something like this:
The
ing back and forth from
(learned in the teach remote menu).
The
or a
Internal settings
electrical result of these triggers is
relay
• select on the PAV/PDSD;
cd1
• select stereo surround
• and change the volume setting to
had been set previously).
The format for giving the direct volume command is as follows:
ume , then two digits, then
TO LEARN OTHER SPECIAL COMMANDS, SELECT "SPECIAL" ON THE
TEACH REMOTE MENU
Finally, the PAV/PDSD provide several special commands that offer home
entertainment enthusiasts and home automation designers more specialized
control over their systems.
and
Control trigger 1 & 2 on
trol the remote turn-on trigger outputs on the rear panel of the Digital Sur-
round Decoder independently of the system itself. For example, should you
decide to use one of these trigger outputs to control amplifiers in the re-
mote zone rather than the local amplifiers, learning these IR commands
would allow you to turn the remote amplifiers on and off (even from across
the house) without affecting the operational status of the main home the-
ater.
The feature will toggle between the configuration estab-
sub/crossover
lished during initial setup and using the front three loudspeakers full-range,
without any help from the subwoofer(s). (Specifically, it turns off the cross-
over and the subwoofer output when
ture may be used to compare the performance of the system configured
with and without the subwoofer(s). (Note that pressing
return the system to its calibrated setup configuration, regardless of its cur-
rent status.)
CONTROL TRIGGER 1
SOURCE:
TYPE:
INTERNAL SETTINGS:
VOLTAGE OUTPUT 12V
refers to what the trigger takes it cue from: either the system chang-
source:
standby
refers to whether the output of the trigger is a
type:
pulse (simulating the action of a momentary-closure contact switch).
within the Digital Surround Decoder determine whether the
(should you require to source more current or a higher voltage than the
;
35 (regardless of where the volume
enter .
make it possible to con-
control trigger 1 & 2 off
sub/crossover off
STANDBY
PULSE
to operate, or an independent
level
or , or even the closing of a dry contact
5V 12V
direct vol-
is selected.) This fea-
will always
recall
IR command
(constant) trigger
51