Ac Power Cord Polarity; Learning Remote Control; Installing Batteries In The Remote Control - PROCEED Digital Surround Decoder User Manual

ac power cord polarity

7
8
9
10 11
To Digital Surround
Decoder
The power consumption of the Digital Surround Decoder is only about 100
watts, about the same as a light bulb. As such most people will leave it on
(or in standby) at all times. If you elect to turn the PDSD completely off
(rather than in placing it in standby), we advise waiting at least five seconds
between power cycles to allow the normal power-up sequence to complete
without interruption.
2 DIGITAL INPUTS 7- 1 1
Please remember to make a note of what sources you connect to which
inputs. Y ou will need to set up the relationships between front panel but-
tons and rear panel connectors later, in the setup menu system.
For now, you can connect any source to any compatible connector—just
keep a list of what-goes-where. (Just such a list is waiting for you later in
this manual. Y ou might want to copy it in order to keep the original clean
for future use.)
accepts digital audio in the
Digital Input 7
"Toslink") digital interface standard from a digital satellite receiver, compact
disc, laserdisc, DVD or other digital source component. Connect the
digital output of your source component to the
round Decoder using a high quality
accept digital audio conforming to the 75Ω
Digital Inputs 8-9
interface standard (via 75Ω cables equipped with
from a digital satellite receiver, compact disc, laserdisc, DVD or other digital
source component. Connect the 75Ω
nent to either of these inputs of the Digital Surround Decoder, using a high
quality 75Ω cable such as Madrigal MDC-2.
accept digital audio conforming to the 75Ω
Digital Inputs 10-1 1
interface standard (via cables equipped with RCA-type connectors) from a
digital satellite receiver, compact disc, laserdisc, DVD or other digital source
component. Connect the 75Ω
either of these inputs of the Digital Surround Decoder, using a high quality
75Ω cable such as Madrigal MDC-2.
If you have the
optional internal RF demodulator
Surround Decoder,
can only be used for that purpose. Connect the RF (Dolby Digital/AC-3)
output from your laserdisc player to Digital Input 11 if you have the internal
RF demodulator installed, using low-capacitance cable such as CZ Gel-2.
To AC mains
1 2 1 2
3
3
EIAJ
optical cable.
EIAJ
/ output of your source compo-
S PDIF
/ output of your source component to
S PDIF
is dedicated to that RF connection and
Digital Input 1 1
1 = Line (hot)
2 = Neutral
3 = Earth ground
optical (sometimes called
EIAJ
input of the Digital Sur-
EIAJ
/ digital
S PDIF
-type connectors)
BNC
/ digital
S PDIF
installed in your Digital
19