Access From The Internet; Setting The Admin Password Over A Secure Connection - Speco VIP2P1 Instruction Manual

3.2. Access from the internet

Once connected, this network camera is accessible on your local network (LAN). To access this
network camera from the Internet (outside of the LAN), you must configure your broadband router to
allow incoming data traffic to this network camera. To do this, enable the NAT-traversal feature,
which will attempt to automatically configure the router to allow access to This network camera. This
is enabled from Setup > System > Network > NAT.
For more information, please see "3.5.4 System>Network>NAT" of User's Manual.

3.3 Setting the admin password over a secure connection

To gain access to the product, the password for
the default administrator user must be set. This
is done in the "Admin Password" dialog, which is
displayed when this network camera is accessed
for the setup at the first time. Enter your admin
name and password, set by the administrator.
Note: The default administrator username is
admin and password is 1234. If the password is
lost, This network camera must be reset to the
factory default settings. See "3.8 Resetting to the
Factory Default Settings".
To prevent network eavesdropping when setting the admin password, this can be done via an
encrypted HTTPS connection, which requires an HTTPS certificate (see note below).
To set the password via a standard HTTP connection, enter it directly in the first dialog shown below.
To set the password via an encrypted HTTPS connection, see "3.5.6 System >Security>HTTPS".
Note: HTTPS (Hypertext Transfer Protocol over SSL) is a protocol used to encrypt the traffic between
web browsers and servers. The HTTPS certificate controls the encrypted exchange of information.
14