Speco VIP2P1 Instruction Manual page 11

• Connecting Ethernet
Connect a standard RJ-45 cable to the network port of This network camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a hub.
Micro SD memory slot

If desired, before closing the Camera Cover, insert a micro SD memory card.
• Connecting the Power
Connect the DC 12V power adapter to the camera.
• Connecting the Wireless using WPS function (VIP2P1N model only)
Follow steps for a proper operation.
1. Make sure your AP (Access Point) and Operating System support WPS (Wi-Fi Protected Setup)
functions. WPS enables easy setup with compatible APs.
2. Press the WPS button on the camera board. You can then see the Status LED is blinking.
4. Press and hold down the WPS button on your AP (some router/AP will have a virtual button on
their management software instead). Refer to your AP's documentation for details using its WPS
functions.
When WPS configuration is done, wireless connectivity will be established and the security
encryption, such as WEP or WPA-PSK, will be synchronized with the AP.
As for IP setting, the camera's use of DHCP or static IP is determined by your configuration on
This network camera via the web- based configuration of firmware. The camera's default is DHCP
for the .
VIP2P1N
Notes:
1. WPS may not work if your AP is configured with a "hidden" SSID.
2. If any WPS-enabled AP is not detected, the camera will search APs for 60 seconds after
pressing the WPS button, and if the camera still can not detect an AP after 1 minute, the
wireless setup will be cancelled.
3. If a camera is assigned with a fixed IP outside the AP's network segment, wireless setup will
fail.
4. A wired connection always has a higher priority, and hence wireless setup will not take effect
when the RJ45 LAN port is connected.
11