Dehydrating; Proofing Bread; Temperature Probe - KitchenAid KERC508 Use And Care Manual

Dehydrating

(on some models)
Dehydrating dries food. For additional information, refer to a book
written specifically about dehydrating or preserving foods.
Dehydration racks and an oven door stop are required, but not
supplied with this oven. See "Assistance or Service" section to
order.
To Dehydrate:
Before dehydrating, prepare food as recommended in the recipe
and arrange on dehydration rack(s). Position racks according to
the following chart. See "Positioning Racks and Bakeware"
section for diagram.
NUMBER OF RACKS
1
2
3
Place the oven door stop over the automatic oven light switch.
1. Oven door stop
2. Automatic oven light switch
1. Press and hold CONVECTION BAKE for 5 seconds.
Press the number pads to enter a temperature other than
140°F (60°C). The dehydrating range can be set between
100°F and 200°F (38°C and 95°C).
2. Press START.
3. Press CANCEL OFF when finished dehydrating.
20
RACK POSITION(S)
3
2 and 4
1, 3 and 5
1 2

Proofing Bread

(on some models)
Proofing bread prepares the dough for baking by activating the
yeast. Follow the recipe directions as a guide.
To Proof:
Before first proofing, place the dough in a lightly greased bowl
and cover loosely with wax paper, coated with shortening. Place
on rack guide two, then place broiler pan on guide one. See
"Positioning Racks and Bakeware" for diagram. Put 2 cups
(500 mL) of boiling water in the broiler pan. Close the door.
1. Press and hold BAKED GOODS for 5 seconds.
The display will show 100°F (38°C).
2. Press START.
Let the dough rise until nearly doubled in size, checking after
20-25 minutes. Proofing time may vary depending on dough
type and quantity.
3. Press LOWER OVEN CANCEL when finished proofing.
Before second proofing, shape the dough, place it in baking
pan(s) and cover loosely with plastic wrap, coated with cooking
spray. Follow the same placement, broiler pan and water and
control steps above. Before baking, remove the plastic wrap.

Temperature Probe

(on some models)
The temperature probe accurately measures the internal
temperature of meat, poultry and casseroles with liquid and
should be used in determining the doneness of meat and poultry.
It should not be used during maxi and econo broiling, convection
broiling, dehydrating or proofing bread.
Always unplug and remove the temperature probe from the oven
when removing food.
To Use:
Before using, insert the probe into the center of the thickest
portion of meat or into the inner thigh or breast of poultry, away
from fat or bone. Place food in oven and connect the temperature
probe to the jack. Keep probe as far away from heat source as
possible. Close oven door.
1
1. Temperature probe jack
2. Temperature probe
1. Press the number pads to enter a probe temperature other
than 160°F (71°C). The probe range can be set between 130°F
and 190°F (54°C and 88°C).
2. Press BAKE, CONVECTION BAKE or CONVECTION ROAST.
Press number pads to enter a temperature other than the one
displayed.
2