System Start-Up Information - Oneida Air Systems Dust Cobra - XCK010000 Owner's Manual

I. System Start-Up Information
Read the installation and maintenance instructions as well as the recommended safety practices in
this manual before assembling and using the Dust Cobra.
The Dust Cobra is heavy! Handling and assembly should always be performed by experienced and
trained personnel who have experience with assembling equipment. In addition to the following
instructional manual, care should be taken to ensure compliance with specifi c safety require-
ments mandated by federal, state and local codes.
This vacuum is designed for indoor / dry material pick-up applications and should not be
used outside or in wet conditions or to pick up liquids.
- Make sure that the voltage nameplate of the device corresponds to the voltage of your network. The plug must
be protected with a minimum of 15 amps. Important! The vacuum is supplied from the factory with a supply
cable with a grounded plug. It must only be connected to an approved grounded receptical.
- Before performing ANY maintenance work, unplug the vacuum from the outlet.
- Warning! Explosion and fi re hazard! Never vacuum fl ammable fl uids or gas, oil, alcohol, solvents, etc. Do not
operate near fl ammable fl uids or gas. Never vacuum warm fl uids or materials at more than 140 deg. F (60 Deg.
C), such as burning cigarettes, ashes, glowing coals, etc.
- Warning! Do not vacuum hazardous / carcinogenic dust unless HEPA fi lter is installed.
- Do not pull the vac by the cable and do not damage the insulation on the cable. If cable is damaged, it must be
replaced immediately.
- Always keep fi lter cartridge clean so the vacuum operates properly.
- Components used in packaging (i.e. - plastic bags) can be dangerous. Keep away from children and animals.
- The use of this machine for anything not specifi ed in this manual may be dangerous and must be avoided.
- The suction nozzle should be kept away from the body. Especially delicate areas such as the eyes, ears and
mouth.
- The equipment should be correctly assembled before use.
- Ensure that power receptical is correct voltage for the machine.
- Check the voltage indicated on the rating plate is the same as the supply voltage.
- Never leave the equipment switched on.
- Never carry out any maintenance on the machine without fi rst disconnecting from the main supply. If machine
is to be left unattended or can be reached by children or others not aware about their action, the electrical sup-
ply should also be terminated.
- The vac should never be immersed in water or a pressure jet of water used for cleaning.
- Periodically examine the power cable and machine for damage. If any damage is found, contact your service
center for repair.
- Should extension cords be used, ensure that the cord rating is suitable for use with the equipment. Do not use
the extension cord coiled as this could result in a voltage drop or overheating of motor.
- If the vacuum should overturn, it is recommended that the machine should be stood up before switching off.
- Service and repairs should be carried out by qualifi ed personnel only. Replacement parts for the machine must
be manufacturers original parts only.
- The manufacturer can not be held responsible for any damage / injury caused to persons or property because
of the incorrect use of the machine or due to procedures being used that are not specifi ed in this instruction
manual.
- Empty dust drum frequently. Never leave fl ammable (including wood dust) material in vac.
2
Safety Instructions to be Strictly Followed.
Caution Caution
Dust Cobra Owner's Manual O.A.S. 2010
c