Network Menu - Epson printer Network Manual

5. Press the Up or Down button until Get IP Address = Auto appears. Press the Enter button
and then the Up or Down button to change to Get IP Address = Panel. Then press the Enter
button. You can use the following methods to get an IP address.
❏ Choose Panel when setting the IP address, subnet mask, and default gateway using the
printer's control panel.
❏ Choose Auto when getting the IP address from a DHCP server. The IP address is automatically
obtained from the DHCP server whenever the printer is reset or turned on.
❏ Choose PING when setting the IP address using the arp/ping command. The network interface
uses the IP address set by the arp/ping command. The settings become available when the
printer is reset or turned off and then back on.
Note:
❏ To use Auto, a DHCP server must be correctly configured on the network. See the online help
of your operating system for detailed instructions.
❏ Choose PING only when setting the IP address using the arp/ping command.
6. Press the Up or Down button until IP = xxx.xxx.xxx.xxx appears. Press the Enter button.
7. Press the Up or Down button until the desired value appears. Then press the Enter button to set
the value.
Note:
Repeat steps 7 and 8 to set the IP address, subnet mask, and default gateway.
8. Press the Start button to exit the control panel menus.
9. Turn off your printer and then turn it back on. Be sure to wait until the initialization is complete.
Print a network status sheet to confirm the new IP address.
Note:
❏ You must first set the IP address before using EpsonNet Config with Web Browser.
❏ See the User's Guide for more information about settings on the printer's control panel.

Network Menu

These items are used to make network settings on the printer's control panel.
EPSON Network Guide
Tips for Administrator 128