Extra Information; Setting Your Sky+ Remote Control To Operate Your Tv - Pace sky+ User Manual

Extra information

❖
Setting your Sky+ remote control to
operate your TV
Your Sky+ remote control can operate both your Sky+ set top box
and your TV.
Your Sky+ remote control should have been set up to work with
your TV when your Sky+ set top box was installed.
If your Sky+ remote control is not correctly operating your TV,
complete the following steps.
Before you start, look up the four-digit code for your brand of TV in
this list.
Brand
Akai
Alba
Amstrad
Bush
Decca
Ferguson
Fidelity
Finlandia
Goodmans
If your brand of TV is not shown here, refer to Remote control setup
codes on page 77.
1. Turn your TV on.
2. Press tv on your Sky+ remote control.
3. Hold down select and the red key together for about two
seconds, until the red light on your Sky+ remote control blinks
twice.
4. Press tv on your Sky+ remote control again.
5. Key in the four-digit code for your brand of TV. The light on
your Sky+ remote control should blink twice.
If the light blinks once only, recheck the code for your brand of TV
and start again at Step 1.
Sky+ User's Guide
Code Brand Code
0098 Granada 0340
0043 Grundig 0345
0063 Hinari 0365
0157 Hitachi 0145
0244 JVC 0053
0293 Matsui 0477
0294 Mitsubishi 0150
0296 NEI 0514
0335 Nokia 0536
Brand Code
Panasonic 0051
Philips 0081
Saisho 0649
Samsung 0060
Sanyo 0159
Sharp 0093
Sony 0000
Tatung 0049
Toshiba 0156
57