Tig Welding Mode - Gtaw Process - Red-D-Arc EXTREME 360 MAP Auto-Line Owner's Manual

6-4. TIG Welding Mode - GTAW Process

!
Weld terminals are
through the remote control in TIG
welding mode.
1 Mode Switch
2 Left Display
3 Right Display
4 Amps Indicator
5 Adjust Control
2
Setup
energized
For typical system connections refer to
Section 6-1.
Rotate Mode Switch to TIG position as
shown.
The preset amperage is shown in the Right
Display with the Amps Indicator lit.
3 4
8 5
1
Operation
The Adjust Control is used to set desired
preset amperage.
A remote control is required to turn on the
weld output.
.
If the remote control has an amperage
adjustment, the adjustment will func-
tion as a percentage of the preset am-
perage.
.
For best results, gently scratch the
tungsten electrode to the work to initi-
ate an arc. To minimize arc flare at the
end of the weld, pull back the electrode
quickly to extinguish the arc.
5
226 611-A
OM-237 881 Page 27