Vlb Logging - Coyote Point Systems E350GX Installation And Administration Manual

Appendix F: Equalizer VLB
7. Click the next icon (
>
the right frame.
To create Event 3:
1. Create the timer event. Right-click on the cluster name in the left frame and select
2. Type in an event name, such as
editor.
Event Trigger
3. In the field, click
functions
arrow next to
running
4. Click the next icon (
>
5. In the field, click
functions
arrow next to
event_wait
6. In the field, click
operators
7. In the field, click
functions
arrow next to
event_wait
expression workbench
8. Click the next icon (
>
the right frame.

VLB Logging

Equalizer VLB writes a number of messages to the equalizer log (
are described below (timestamps normally displayed at the beginning of each line have been omitted):
Logged into Virtual Machine manager successfully
Failed to connect to Virtual Machine manager
Failed to log into Virtual Machine manager
The messages above indicate that Equalizer attempted to log into the vCenter or ESX Server IP
configured on the VLB tab. The status of the first login attempt after a reboot is recorded in the
log; subsequent attempts are only logged if the login status changed since the last login. For
example, the first successful login attempt is logged; subsequent successful attempts are not
recorded. Likewise, the first failure is recorded; no further messages are logged during
subsequent attempts until a login attempt succeeds.
VLB: probe: Server IP_address VLB state changed from old_value to new_value
A message in the above format indicates that the VLB agent return value for the virtual machine
at IP_address has changed since the last probe of the vCenter (or ESX Server). Both the
previous return value (old_value) and the latest return value (new_value) are logged in the
message.
304
)at top, and then to create the event. The Configuration tabs for the event open in
commit
, or accept the default. Click the next icon (
reboot-timer
. In the
running expression workbench
. Select and click
sv00 accept
)at top to open the
Event Action
. In the
event_wait expression workbench
. Select
poweroff-sv00
.
&&
. In the
event_wait expression workbench
. Select
poweron-sv00
should now look like this:
)at top, and then to create the event. The Configuration tabs for the event open in
commit
field at bottom, click on the drop-down
. The
expression workbench
editor.
field at bottom, click on the drop-down
, and then type " " for the
900
field at bottom, click on the drop-down
, and then type " " for the
900
Equalizer > Status > Event Log
Equalizer Installation and Administration Guide
from the menu.
Add Event
)at top to open the
>
should now look like this:
. Click
wait seconds accept
. Click
wait seconds accept
). These messages
.
. The