Mounting The Camera - Sony F35 Operation Manual

1
2
When the supplied center handle is attached to the top of
the camera head, you can attach the viewfinder to the
viewfinder shoe of the center handle. In this case, first
remove the viewfinder shoe from the camera head.
For details on the center handle, see "2-7-2 Center Handle
(Supplied)" (page 28).
Note
When the L handle is attached to the camera head, the
attaching condition may be limited, owing to the
viewfinder position and the rotating position of the hood.
When the second viewfinder is required
Connect it to the VF2 connector.
Using the menus, you can specify the display condition
independently of the viewfinder connected to the VF1
connector.
Note
When two viewfinders are connected at the same time (via
the VF1 and VF2 connectors), the HDVF-C950W cannot
be used because of a limitation of current capacity.
To detach the viewfinder
Loosen the viewfinder positioning ring, pull on the
viewfinder stopper, then pull out the viewfinder by sliding
it in the direction opposite that when attaching.

2-6 Mounting the Camera

to a Tripod
TA LL Y
HIG H
LOW
OFF
DISP LAY
ASP ECT
A
ZE BR
ON
Two tripod receptacles (for
MOM ENT OFF
B& W
MA G
provided on the bottom of the camera head.
Notes
• Select an appropriate hole, considering the balance of the
weight of the camera. If an inappropriate hole is selected,
the camera may fall over.
• Check that the size of the selected hole matches that of
the screw of the tripod. If they do not match, the camera
cannot be attached to the tripod securely.
3
/ " camera screws) are
8
Tripod receptacles
Mounting the Camera to a Tripod
27