Storage Of The Ohb File; Reading Of The User Gamma; Reading Of The User Mlut - Sony F35 Operation Manual

2
Position the pointer to READ (MS t CAM) and push
on the MENU SEL/ENTER dial.
The camera will be adjusted according to the data of the
reference file.

5-3-6 Reading of the User Gamma

To read out gamma-curve (User Gamma) data that have
been created using CvpFileEditor application software
from the "Memory Stick," use the <USER GAMMA>
page of the FILE menu.
< U S E R G A M M A >
U S E R G A M M A
R E A D ( M S
c
F I L E I D :
C A M C O D E
D A T E
M O N I L U T
R E A D ( M S
Insert the "Memory Stick" into the "Memory Stick" slot of
the camera. Position the pointer to READ (MS t CAM)
under USER GAMMA, and push on the MENU SEL/
ENTER dial.
For details on how to use the User Gamma, see "3-11-4
Using the User Gamma" (page 62).

5-3-7 Reading of the User MLUT

To read out a monitor LUT from the "Memory Stick," use
the <USER GAMMA> page of the FILE menu.
< U S E R G A M M A >
U S E R G A M M A
R E A D ( M S
F I L E I D :
C A M C O D E
D A T E
M O N I L U T
c R E A D ( M S
Insert the "Memory Stick" into the "Memory Stick" slot of
the camera. Position the pointer to READ (MS t CAM)
under MONI LUT, and push on the MENU SEL/ENTER
dial.
For details on how to use the User Gamma, see "3-11-4
Using the User Gamma" (page 62).
F 0 4 T O P
C A M )
t
C A M )
t
F 0 4 T O P
C A M )
t
C A M )
t

5-3-8 Storage of the OHB File

Use the <OHB FILE> page of the FILE menu.
1
Execute STANDARD on the <REFERENCE> page of
the FILE menu.
2
Using the MAINTENANCE menu, perform necessary
settings for the items marked with "a" in the "O"
column of the table in "5-2 List of Items Stored in
Files" for the file you wish to store.
3
Call up the <OHB FILE page of the FILE menu,
position the pointer to STORE FILE then push on the
MENU SEL/ENTER dial.
< O H B F I L E >
c S T O R E F I L E
Adjusting the ND offset values
If an ND filter is attached to the matte box, etc., the white
balance may be in variance. In such a case, adjust the ND
offset so that you can retrieve the white balance
compensation value using the ND filter selection page on
the subdisplay.
The offset values ND: 2 to 5 are stored with respect to the
white balance stored for ND: 1 as the reference.
Adjustment procedure
1
Switch the camera to Custom mode, referring to "3-1-
2 Switching of the Basic Operation Modes" (page 33).
2
Execute STANDARD on the <REFERENCE> page of
the FILE menu.
3
Execute AUTO BLACK on the <AUTO SETUP> page
of the MAINTENANCE menu.
4
Connect a waveform monitor via the MONITOR OUT
HD SDI connector 1 or 2 of the camera.
5
Attach the ND filter having the lowest permeability
among the ND filters to be used with this camera, and
shoot a gray-scale chart.
Check that the lighting condition permits a video level
in the range of 560 to 630 mV to be obtained and write
down the current video level.
F 0 6 T O P
111
File Operations