Table of Contents
Advertisement
12
Start the fasteners into each
5.1.3
of the six remaining mount-
ing holes. Align the keyholes
of the frame to the heads of
the fasteners and slide the
frame down onto the fasten-
ers. Ensure the frame is plumb
and level before tightening the
fasteners. NOTE: It is recom-
mended that the gas and
electrical be connected to
the appliance at this stage.
Both must enter the appli-
ance at the opening created
between the bottom of the
Torch and the bottom of the
mounting frame.
Slide the front of the cabinet
5.1.4
over the mounting frame, en-
suring the "mesh" is to the top.
Start each of the four screws
(supplied) through the slots.
Once the cabinet has been
adjusted for depth the four
screws can be tightened.
5.2
RAIN TABS
When shipped, the rain tabs should be at a 90º angle.
Push the rain tabs down until they are at an approxi-
mate 60º angle to assist rain in running off and out of
the unit.
W415-0689 / A / 06.08.10
3
KEYHOLE
RAIN
TAB
4
Advertisement
Table of Contents
