Table of Contents
Advertisement
5.0 FINISHING
5.1
TMCSS MOUNTING CABINET INSTALLATION
BEFORE STARTING THE INSTALLATION, REMOVE THE PROTECTIVE LAYER FROM ALL THREE
COMPONENTS THAT MAKE UP THE GSST8 (CABINET, FRAME AND TORCH).
NOTE: It is recommended that all fasteners be
stainless steel.
Using the installation template (W122-0401)
5.1.1
supplied, determine the best mounting location
for your new Torch. (Refer to your manual for
clearances) Mark all 14 hole centres on the
wall (surface) using the template.
Remove the template. Depending on the sur-
5.1.2
face and fasteners, drill the appropriate holes.
Hold the Torch up, aligning the mounting
brackets to the mounting holes. Secure the
Torch to the wall using the appropriate fasten-
ers. NOTE: The Torch has been designed
to have a 1/2" clearance between the rear
outer panel and the mounting surface.
WARNING
!
1
CABINET
11
INSTALLATION
TEMPLATE
TORCH
MOUNTING
FRAME
2
MOUNTING
BRACKET
W415-0689 / A / 06.08.10
Advertisement
Table of Contents
