Connecting Inputs - Outline TFive User Manual

Professional amplifiers

1.5 Connecting Inputs

rear side of the amplifier. The polarity is shown in figure 1.5.1.
IN2
The figure below shows the connection of analog input for balanced and unbalanced line. You can use both configuration,
but you must consider that unbalanced long line can introduce noise in the audio system. The Link switch located in the
rear panel is for direct paralleling the rear input connectors. You can use the remaining input connector to carry signal to
other amps.
For T Five, the input connections are showed in the figure below; analog input for balanced and unbalanced line is also
available for this models.
T Five model
Tel. +39-30-3581341 Fax +39-30-3580431 — Web Site: www.outline.it E-Mail: info@outline.it
. Input connections are made via the 3-pin XLR-female type or 1/4" phone Jack connectors on the
OUT2 OUT1 IN1
LINK ON OFF
GND
IN(-)
IN(+)
Balanced input
signal source input
XLR female connector
signal source output
XLR male connector
Outline s.r.l. - Via Leonardo da Vinci, 56 - 25020 Flero (Brescia) - Italy
pin2 - IN(+)
pin1 - GND
pin3 - IN(-)
IN(-)
IN(+)
figure 1.5.1
Unbalanced input
figure 1.5.2
pin1 - GND
pin2 - IN(+)
pin3 - IN(-)
pin 2 - IN(+)
pin1 - GND
pin 3 - IN(-)
GND
/
SHIELD
IN(+)
XLR female
XLR male
T Series
7