Safety Rules; Speaker Damage; Speaker Output Shock Hazard - Outline TFive User Manual

Professional amplifiers
Precautions regarding installation
Placing and using the amplifier for long periods on heat-generation sources will affect performances. Avoid placing the
amplifier on heat-generating sources. Install this amplifier as far as possible from tuners and TV sets. An amplifier installed
in close proximity to such equipment may cause noise or degradation of the picture.
WARNING:
To prevent fire or electric shock:
·
The ventilation should not be impeded by covering the ventilation openings with items such newspapers, table-
clothes, curtains etc.
·
Do not expose this equipment to rain or moisture.
·
Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be
placed on the apparatus".
This device must be powered exclusively by earth connected mains sockets in electrical networks compliant to the IEC 364
or similar rules.
Is absolutely necessary to verify this fundamental requirement of safety and, in case of doubt, require an accurate check by
a qualified personnel.
The constructor cannot be considered responsible for eventual damages caused to persons, things or data for the missing
of accurate earth link.
·
Before powering this device verify that the amplifier is supplied with the correct voltage rating.
·
Verify that your mains connection is capable to satisfy the power ratings of the device.
·
Do not spill water or other liquids into or on the unit.
·
Do not use this unit if the electrical power cord is frayed or broken.
·
Do not remove the cover. Removing the cover will expose you to potentially dangerous voltage.
·
No naked flame sources such like lighted candles should be placed on the amplifier.
·
Provide sectioning breaker between mains connections and apparatus. Suggested device is 32A/250Vac, C or D
curve, 10KA
·
The inlet power supply cord plug is useful as disconnection device
·
The power cord type is LAPP CABLE OLFLEX191 3G6 / SJT 3XAWG10 SALCAVI (Bahoing SJT 3x16AWG or I-
sheng SGIS 3G1,5mmq for T Five)
Contact the authorized center for ordinary and extraordinary maintenance
The Outline T Series amplifiers are among the most powerful professional amplifiers available and are capable of producing
much more power than many loudspeakers can handle. It is the user's responsibility to use suitable speakers with the
amplifier and to use them in a sensible way that will not cause damage. Outline will not be responsible for damaged
speakers. Consult the speaker manufacturer for power-handling recommendations. Even if you reduce the gain using the
amplifier's front panel attenuation controls, it is still possible to reach full output power if the input signal level is high
enough.
A single high-power crescendo can damage high-frequency drivers almost instantaneously, while low-frequency drivers can
usually withstand very high, continuous power levels for a few seconds before they fail. Reduce power immediately if you
hear any speaker "bottoming out" - harsh pops or cracking distortion that indicate that the speaker voice coil or diaphragm
is striking the magnet assembly. Outline recommends that you use amplifiers of this power range for more headroom
(cleaner sound) rather than for increased volume.
A Outline T Series amplifier is capable of producing hazardous output voltages. To avoid electrical shock, do not touch any
exposed speaker wiring while the amplifier is operating.
This manual contains important information on operating your T Series amplifier correctly
and safely. Please read it carefully before operating your amplifier. If you have any questions,
contact your Outline dealer.
Tel. +39-30-3581341 Fax +39-30-3580431 — Web Site: www.outline.it E-Mail: info@outline.it

Safety Rules

Speaker damage

Speaker output shock hazard

Outline s.r.l. - Via Leonardo da Vinci, 56 - 25020 Flero (Brescia) - Italy
.
T Series
3