Dump Mode; Printer Defaults - Printronix M4L Administrator's Manual

Dump Mode

Printer will enter dump mode after printing Configuration Page. In dump mode, all characters will
be printed in 2 columns as shown. The left side characters are received from your system and
right side data are the corresponding hexadecimal value of the characters. It allows users or
engineers to verify and debug the program.
ASCII Data
Note:
Dump mode requires 4" paper/label width.
Exit Dump mode by turning off / on the power or by pressing the FEED key. The LCD will show
"Ready" for normal printing operation.

Printer Defaults

Printer configuration will be restored to defaults as below after initialization.
Speed
Density
Media Width
Media Height
Sensor Type
Print Direction
Reference Point
Gap Offset
Post-Print Action
Serial Port Settings
Code Page
Country Code
Clear Flash Memory
Note: When printer initialization is done, calibrate the gap or black mark sensor before printing or
attempting any Self tests.
24
Parameter
50.8 mm/sec (2 ips)
8
4" (101.5 mm)
4" (101.5 mm)
Gap sensor
0
0,0 (upper left corner)
0
Tear mode
9600 bps, none parity, 8 data bits, 1 stop bit
850
001
No
Hex decimal data related to left column
of ASCII data
Default setting