Installing The Remote Keypad To The Board (Use Option) - Toshiba RKP004Z Instruction Manual

2. Installing the LCD remote keypad

2.2 Installing the remote keypad to the board (Use option)

The remote keypad can be mounted on a board by means of an IP54 attachment
(optional).
In addition, if an IP65 attachment (optional) is used in combination with an IP54
attachment, the remote keypad can be installed where it may be splashed with water.
● Never connect the unit to any inverter other than a VF-AS1/PS1/MB1
Prohibited
Turn off the inverter, as shown in the figure below.
*Below is installation drawing for VF-AS1/PS1
Tapping screws (4 pieces)
Used to s ec ure the attachment.
IP65 attachm ent (optional)
Used to be attac hed to the IP54 attachment
*
Leave a space of 45mm or more
for the interconnect cable.
series inverter or any communication device. Do not use any cable other
than an optional interconnect cable designed specifically for the unit.
If the correct cable was not used, this might cause the unit to break down
and result in an electric shook or fire.
Warning
Make a hole in the board, as shown in
the figure below.
5
* The pin configuration of the dedic ated
interconnect cable is different from that of
any other commercially available cable.
Therefore, be sure to use t he dedicated
interconnect cable.
2-2
115
105 5
IP54 attachm ent
(optional)
Remote keypad
Dedicated i nterconnect cable
*
(optional)
4-Ф4