Connecting To A Telephone; Connecting The Power Cord - Cisco 575 LRE CPE Installation Manual

Chapter 2 Installation

Connecting to a Telephone

Step 1
Step 2

Connecting the Power Cord

Step 1
Caution
Step 2
78-11469-01
Connect one end of a telephone cord (not included) to the PHONE port of the
CPE. (See Figure 2-5.)
Note Use a standard telephone cord with RJ-11 connectors on both ends.
Connect the other end of the telephone cord to a telephone.
Note If you have other telephones that share the same line but that are not
connected through the CPE, we recommend connecting those
telephones through a microfilter with a 300-Ohm termination.
Microfilters can improve voice call quality when voice and data
equipment are using the same telephone line. They also prevent
nonfiltered telephone rings or nonfiltered telephone transitions (such
as on-hook to off-hook) from interrupting the LRE connection. For
more information about microfilters, contact your Cisco sales
representative.
Connect the power cord to the power connector on the CPE rear panel. See
(Figure 2-5.)
Use only the AC power cord and adapter shipped with the CPE.
Slide the power cord under the hooks on the bottom of the CPE. (See
Cisco 575 LRE CPE Hardware Installation Guide
Connecting to a Telephone
Figure 2-8.)
2-15