Cisco 575 LRE CPE Installation Manual page 33

Chapter 2 Installation
Locate the screw template. The template is used to align the mounting screw holes
Step 1
and is also used as a guide to make sure the screws are installed into the desktop
with proper clearance.
Note
Step 2 Position the screw template so that the two side-by-side slots are facing away from
the floor. (See
after they are connected.
Note
78-11469-01
The template has adhesive to hold it in place while you drill holes
underneath the desktop. If you will be using the same screw template
to install several CPEs, do not use the adhesive. In this case, hold the
template in place with your hand while you drill the screw holes and
insert the screws.
Figure 2-3.) This ensures the cables will face towards the floor
Do not attach the screw template to the wall yet.
Cisco 575 LRE CPE Hardware Installation Guide
Installing the CPE On a Wall
2-9