Cisco 575 LRE CPE Installation Manual page 31

Chapter 2 Installation
Figure 2-1 Installing the Mounting Screws Under a Desk
Desktop
Screw template
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
78-11469-01
Screw
Screw
Peel the adhesive strip off the bottom of the screw template, and attach it to the
underside of the desk.
Use a 1/44-inch bit to drill a 1/2-inch-deep hole in the two screw template slots.
(Optional) If you wish to attach the cable lock after the cables are installed, drill
a 1/2-inch-deep hole in the cable lock hole. For more information, see the
"Attaching the Cable Lock" section on page
Insert two screws in the slots on the screw template, and tighten until they touch
the top of the screw template.
Remove the screw template from underneath the desk.
Slide the CPE onto the mounting screws until it locks in place. (See
Installing the CPE Under a Desk
Cable
lock hole
Adhesive
2-16.
Cisco 575 LRE CPE Hardware Installation Guide
Wall
at least
1/2 in.
(12.7 mm)
3 in.
(7.6 cm)
Figure 2-2.)
2-7