Unpacking; Short Form Instructions - Inter-m V2-1000 Operation Manual

PROFESSION L POWER MPLIFIER

Unpacking

Unpacking
Please take a few minutes to read this manual to familiarize yourself with important information regarding
installation, product features, and operation.
s with most electronic devices, original packaging (or equal) is required in the unlikely event that the product
needs to be returned for servicing.

Short Form Instructions

Short Form Instructions
1. Do not connect the C power until step 6. The ac mains power switch should be in the off position.
2. djust both of the level controls to the fully attenuated position(turn fully counter-clockwise).
3. Connect an appropriate line level input signal to the balanced XLR connector marked inputs.
4. Move the mode selector to the desired position. The Stereo position is the most common.
5. Connect the outputs to the speaker load according to the mode of operation determined in the previous step.
6. With the ac mains power switch in the off position, connect to an appropriate C source.
7. Depress the ac mains power switch to the on position. The indicator 'POWER' will illuminate dimly and then
fully after a few seconds.
8. The product is ready for operation. Slowly increase the level control to the desired operating level.
illuminating the clip indicator and do not apply too much power to the speakers.
9. Operate the product and the system in a manner which does not illuminate the clip warning indicator.
2
V2-1000/2000/3000/4000
void