Preview Menu - HIKVISION DS-7200HVI-ST Series Quick Start Manual

the DVR are connected properly.
PTZ Settings
To configure PTZ settings:
1. Click Menu > Settings > PTZ to enter the PTZ Settings
menu.
2. Select channel
where PTZ camera
is installed next to
Camera label.
3. Configure the
settings of baud rate, date bit, stop bit, parity, flow control,
PTZ protocol and address.
4. Click OK to save settings and exit the PTZ Settings menu.
PTZ Control
The PTZ control panel in the live preview window provides
a series of PTZ control buttons, as shown in the following
figure:
1. Directional Pad/Auto-scan Buttons: Controls the
movements and directions of the PTZ. The center button
is also used to start auto-scan of PTZ.
2. Zoom: Used to zoom in and out with the PTZ.
3. Focus: Used to adjust the focus of the PTZ.
4. Iris: Used to open up or close the iris of the PTZ.
5. Speed: Adjusts the movement speed of the PTZ.
6. Light: Turns PTZ light (if applicable) on and off.
7. Wiper: Turns PTZ wiper (if applicable) on and off.
8. Zoom In: Instantly zooms PTZ in.
9. Center: Centers PTZ. Camera: Select a PTZ camera.

Preview Menu

Call Preset: Call a PTZ preset.
Call Patrol: Call a PTZ patrol.
Call Pattern: Call a PTZ
pattern.
Preset Settings: Enter PTZ
preset configuration menu.
Patrol Settings: Enter PTZ
patrol configuration menu.
Pattern Settings: Enter PTZ pattern configuration menu.
PTZ Menu: Enter PTZ menu.
PTZ Settings: Enter PTZ settings menu.
Playback
Playback by Search
To playback files from a general search:
1. Enter into the Video Search menu by clicking Menu >
Video Search.
2. Select General tab,
and Set the search
parameters by
selecting cameras to
search, video/file type
and the start/end
time.
3. Click the Play button
to start playback of
all the files found
with the specified
search criteria or
click the Search
button to bring up the list of search results. After search
results are presented, select the file you would like to
playback and press Play to enter synchronous playback
cameras selection.
4. Recordings will automatically be played back in the
Playback interface.
Playback from Live Preview
You may also instantly playback from a channel while
watching a Live Preview. The playback will be of recordings
from the past 5 minutes.
To playback from a channel instantly in Live Preview:
• Using a Mouse:
1. Right-click the mouse on desired channel and select the
Playback button.
2. Recordings from
the selected
channel will start
playing back in the
Playback interface.
An Attention
DS-7200HVI-ST Series DVR
Quick Start Guide -
3