How To Connect With Dip Switch Set-Up - Firmtech FB200AS User Manual

FB200AS User Guide Version 1.0
(8) Click Set-up Start (<Figure 10-5> blue borders) button after setting each value (<Figure 10-5> red
borders N.1 - Com Port connected to FB200AS ,
(9) If the Status Display of Procedures (<Figure 10-6> N.1 red borders) changes color into green,
Connection Set-up is completed. With Clicking the End button(<Figure 10-6> Blue borders), finish
the C-Wizard
(10) Set Function Dip Switch #3 to MASTER after turn the FB200AS(2)'s power off.
(11) Turn ON the FB100AS(2) and check status LED of FB100AS(2) is turns ON in 1~10seconds. If LED is
ON, the section of Bluetooth is connected properly and Data Transmission is usable

10.2 How to connect with Dip Switch Set-up

FB200AS can perform data communication once you change the Dip Switch Set-up.
The following is the method of setting the Dip Switch.
(1) Set Baud rate Dip Switch of FB200AS(1) to the proper speed for communication
(2) Set FUNCTION Dip Switch #3 of FB200AS(1) to SLAVE.
(3) Turn the power of FB200AS(1) on.
(4) Set Baud rate Dip Switch of FB200AS(2) to the proper speed for communication.
(5) Set FUNCTION Dip Switch #3 of FB200AS(2) to MASTER.
(6) Turn the power of FB200AS(2) ON.
(7) If Status LED of FB200AS is turned on shortly, it means the wireless section of Bluetooth is properly
connected, so Data transmission can be performed.
10
<Figure 10-6 Connection Wizard Step 6>
Connecting the wireless section of Bluetooth
N.2 - 0x02) in blanks.
Page 18 / 27