How To Connect With Dip Switch Set-Up - Firmtech FB100AS-F User Manual

FB100AS-F User Guide
(9) Click Set-up Start (<Figure 11-5> blue borders) button after setting each value (<Figure 11-5> red
borders N.1 - Com Port connected to FB100AS-F,
(10) If the Status Display of Procedures (<Figure 11-6> N.1 red borders) turns red into green,
Connection Set-up is completed. With Clicking the End button(<Figure 11-6> Blue borders), finish
the C-Wizard
(11) Set Function Dip Switch #3 to MASTER after turn off the power of FB100AS-F(2)'s power off.
(12) Turn ON the FB100AS-F(2) and check status LED of FB100AS-F(2) is turns ON in 1~10seconds. If
LED is ON, the section of Bluetooth is connected properly and Data Transmission is usable

11.2 How to connect with Dip Switch Set-up

FB100AS-F can perform data communication once you change the Dip Switch Set-up.
The following is the method of setting the Dip Switch.
(1) Set Baud rate Dip Switch of FB100AS-F(1) to the proper speed for communication
(2) Set FUNCTION Dip Switch #3 of FB100AS-F(1) to SLAVE.
(3) Turn the power of FB100AS-F(1) on.
(4) Set Baud rate Dip Switch of FB100AS-F(2) to the proper speed for communication.
(5) Set FUNCTION Dip Switch #3 of FB100AS-F(2) to MASTER.
(6) Turn the power of FB100AS-F(2) ON.
(7) If Status LED of FB100AS-F is turned on shortly, it means the wireless section of Bluetooth is
properly connected, so Data transmission can be performed.
Version 1.0
<Figure 11-5 Connection Wizard Step 5>
<Figure 11-6 Connection Wizard Step 6>
Connecting the wireless section of Bluetooth
11
N.2 - 0x02) in blanks.
Page 21 / 30